Reasons for the heating of the nozzle of the laser cutting machine:1. Is the cooling air (cooling water) of the laser nozzle turned on? whether the requirements are met.2. The laser focusing optical path may be offset, and part of the laser is irradiated on the nozzle.3. The diameter of the laser no

water coolingIn high temperature weather, the deterioration rate of cooling water will also be accelerated. It is recommended that users of laser cutting machine use regular distilled water or pure water, and clean the scale regularly, so as not to cause the scale attached to the laser and the pipel

First of all, it is necessary to regularly check and maintain the external optical path of the laser generator. The power of the laser cutting machine will decrease after a period of continuous use. When the power drops and affects production, maintenance of the laser and the external optical path i

Rainstorm prevention measures1. Add the safety protection device and power-off protection device of the laser cutting machine;2. The laser cutting machine should be regularly maintained and maintained to maintain a good operating state;3. Frequent safety inspection and debugging to eliminate the uns

Cutting too fast1. The short time the laser beam and the material are in contact with each other can result in failure to cut and sparks.2. Some areas can be cut off, but some areas cannot be cut off.3. Causes delamination of the entire cut section.4. As a result, the plate cannot be cut in time, th